Back Cover - Haier GE GFW510SCN0 Technical Service Manual

3. Remove the lock assembly from the front
panel and disconnect the harness from the
door lock assembly and set aside.
4. Remove the door assembly (See Door
Removal, under Door in this section) to
reveal and remove the door latch harness
holder.
5. Push down on the tab securing the harness
holder to the front panel and remove.
Disconnect the harness connector from the
holder.
6. If just reversing the door, reconnect the lock
assembly to the harness connector on the
opposite side.

Back Cover

The back cover must be removed to access the
belt, pulley, pressure chamber, and motor.
Back Cover Removal
The back cover is attached to the washer with
eight Phillips-head screws. Pull the bottom of
the panel outward slightly and slide downward to
remove from the underside.
– 40 –