Door Reversal - Haier GE GFW510SCN0 Technical Service Manual

Door Reversal

WARNING: Shock Hazard Unplug the appliance
or turn off the circuit breaker before servicing.
Pressing the Power pad DOES NOT disconnect
power.
WARNING: Shock Hazard
Certain internal parts are intentionally not
grounded and may present a risk of electric shock
only during servicing.
Service Personnel: DO NOT contact the
following parts while the appliance is energized:
water valve, drain pump, NTC, heater, door lock,
inverter board, motor and MC board.
Tools Needed
• Phillips-head Screw-driver
• Lock Bar, Provided With
Machine
Step 1: Remove The Door Assembly
• Open the washer door.
• While supporting the door, remove the 6
screws from the hinge in the washer face.
• Lift the door assembly to remove it from the
washer face and set it on a protective surface.
Door and Hinge
Assembly
Hold the Door and
Remove Hinge Screws
from the Washer
Step 2: Remove Hinge Cover And Door Hinge
• Remove the three screws from the hinge
cover and remove the cover.
• Remove the six screws from the hinge and
remove the hinge from the door.
Hinge Cover
Hinge
Step 3: Remove, Reverse And Replace Door
Striker
• Remove the two screws from the striker.
Rotate the striker 180° and reinstall the striker
with its screws.
– 34 –