Table of Contents
Advertisement
Fig. 11.10
ArtNo.215-0026 - Handle gaskets fixed
Fig. 11.11
Art No 215-0028 - Handrail fascia fixings
Fig. 11.12
Fig. 11.13
ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)
Fig. 11.14
ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)
Outer plinth xing screw
Inner plinth
INSTALLATION
Check the appliance is electrically safe when you have finished.
Outer plinth
Final fitting
Fitting the handles and handrail (depending on model)
Remove the 4 mm Allen screws from the doors (Fig. 11.10).
Fit the door handles and secure using the 4 mm screws.
The handles should be above the fixings.
n
Remove the 4 mm Allen screws from the top corners of the
fascia (Fig. 11.11). Fit the front handrail in position and
secure using the 4 mm screws.
Fitting the 1-piece plinth
Loosen the three screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw. Twist
and fit each end keyhole over their respective screws. Tighten
the fixing screws (Fig. 11.12).
Fitting the 2-piece plinth
Fit the inner plinth to the bottom front of the cooker using
the 4 screws provided (Fig. 11.13).
Fit the outer plinth (2 screws, 1 each end) to the inner plinth.
The height of the outer plinth can be adjusted by sliding it up
or down via the slotted hole (Fig. 11.14).
Fitting the splashback (optional)
Position the splashback on the rear of the hotplate and secure
with the screws supplied.
Customer care
Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
34
Advertisement
Table of Contents
