Table of Contents
Advertisement
The oven light is not working
The bulb has probably blown. You can buy a replacement
bulb (which is not covered under the guarantee) from most
electrical stores. Ask for an Edison screw fitting 15 W 230 V
lamp, FOR OVENS (Fig. 10.1). It must be a special bulb, heat
resistant to 300 °C.
Before removing the existing bulb, turn off the power supply
and make sure that the oven is cool. Open the oven door and
remove the oven shelves.
Locate the bulb cover and unscrew it by turning it counter-
clockwise – it may be very stiff (Fig. 10.2).
Taking care to protect your fingers with a glove in case the
bulb should shatter, unscrew the old bulb.
Screw in the new bulb clockwise and then screw the bulb
cover back on. Turn on the electricity supply and check that
the bulb now lights.
The oven door is misaligned
The bottom hinge of either oven door can be adjusted to
alter the angle of the door (Fig. 10.3). Loosen the bottom
hinge fixing screws and use the notch and a flat bladed
screwdriver to move the position of the hinge to set the
hinge position (Fig. 10.4).
Retighten the hinge screws.
ArtNo.320-0006 Oven door hinge adjustment 1
Effect of hinge adjustment – exagerrated for clarity
ArtNo.320-0007 Oven door hinge adjustment 2
Oven door omitted for clarity
29
ArtNo.324-0005 Oven light bulb
Centreline of hinge pin
Fig. 10.1
Fig. 10.2
Fig. 10.3
Fig. 10.4
Advertisement
Table of Contents
