Configuration Of The Docking Station; Calibration Of The Docking Station; Initialization Of The Robot Lawn Mower; Programming Virtual Perimeters, Transition Routes And Areas To Be Avoided - Stiga A1500 Instruction Manual

4.7.5. CONFIGURATION OF THE DOCKING STATION

Before using the robot lawn mower, the docking station must be con昀椀gured, (see par. 4.7.3).

4.7.6. CALIBRATION OF THE DOCKING STATION

Immediately after completing the docking station set-up, it is mandatory and required by the app to
calibrate the return to base position.
The calibration allows the robot lawn mower to determine the correct alignment to the charging contacts,
using the reading of the radio signal emitted by the antenna located underneath the base of the docking
station.
Procedure:
1. Place the robot lawn mower on the docking station and connect it to the charging contacts.
2. If necessary, lift the robot lawn mower slightly by the rear handle and align it with the docking station
to make sure it is perfectly aligned with it.
3. Check on the robot lawn mower keypad whether the 'ALARM' light icon is switched o昀昀, if not, reset the
alarms before proceeding (see section 5.3.7).
4. Close the cover.
5. Start the calibration following the App Calibration Wizard.
6. Wait until a calibration con昀椀rmation message appears.
NOTE: If the procedure is not completed within 5 minutes after connecting the robot lawn mower
to the charging contacts, the calibration is cancelled. It is necessary to disconnect the robot from
the charging contacts and repeat the procedure from step 1.

4.7.7. INITIALIZATION OF THE ROBOT LAWN MOWER

The initialization of the robot lawn mower is mandatory and required by the app:
• When starting the product for the 昀椀rst time.
• When the robot lawn mower is switched on or restarted.
• When the robot lawn mower is moved manually.
First-time product start-up procedure
1. Position the robot lawn mower so that it will be able to move forward at least 3 m without encountering
any obstacles.
2. Start the initialization as requested by the app and wait for the completion of the procedure. The robot
lawn mower moves forward by taking three steps of approximately 1 m.
How to proceed when starting or moving the robot lawn mower manually:
1. Place the robot lawn mower inside a programmed area in a position that will allow it to move forward
at least 3 m while remaining within the virtual boundary without encountering obstacles.
2. Start the initialization as requested by the app and wait for the completion of the procedure. The robot
lawn mower will move forward by taking three steps of approximately 1 m.

4.7.8. PROGRAMMING VIRTUAL PERIMETERS, TRANSITION ROUTES AND AREAS TO BE AVOIDED

Before proceeding with the programming, make sure the following steps have been completed: device
pairing (par. 4.7.3), con昀椀guration of the docking station (par. 4.7.5), calibration of the docking station (par.
4.7.6), initialization of the robot lawn mower (par. 4.7.7).
The programming of the virtual perimeters, transition routes and areas to be avoided is performed using
the respective STIGA.GO App wizard. The procedures require to manually guide the robot lawn mower,
walking beside it.
Following are the most relevant steps:
EN 4. INSTALLATION 35