Installation Of The Satellite Reference Station - Stiga A1500 Instruction Manual

4.5.2. INSTALLING THE SATELLITE REFERENCE STATION
ELECTRICAL HAZARD:
Only use the battery charger
and power supply provided by
the manufacturer. Improper use
may cause electric shock and\or
overheating.
ELECTRICAL HAZARD:
A socket must have been
prepared near the installation
area to connect it to electricity.
Make sure that connection
to the power supply network
conforms to laws in force of the
Country where it is used.
The satellite reference station (A) is supplied with the docking station and is installed under the protective
cover (B).
It is powered by the docking station through a connector (C).
If the docking station (D) is not positioned in an area where the sky is fully visible, the satellite reference
station (A) must be removed from the docking station and installed in an area where the sky is fully visible.
In this case, the installation of the satellite reference station (A) must be carried out using the mounting
bracket (E). to supply power it is possible to use:
• a 5 metre extension cable (L) (included).
• a 15-metre extension cable that can be purchased separately (L).
• a separately purchased power supply unit (F) and the connection to an electrical outlet.
If the reference station is installed separately, a minimum installation height of 2.5 metres above the
ground is recommended.
Prepare the installation area of the power supply unit (F) so that it is protected from solar radiation and in
order to prevent it from being submerged in water at any time.
WARNING:
The power cable, power supply unit, extension cord and all other electric cables
which do not belong to the product must remain outside the cutting area to
maintain their distance from hazardous moving parts and prevent damage to
cables which may come into contact with live parts.
WARNING:
The power supply cable and power supply unit must be positioned in an area
where they do not pose any danger to children, persons or animals.
CAUTION:
For safety reasons, the satellite reference station must never be moved after the
programming of the virtual perimeters, transition routes and areas to be avoided.
The robot lawn mower could exit the programmed work area. If the reference
station is moved, the programming must be repeated.
EN
CAUTION:
The circuit provided must be
protected by a residual current
device (RCD) with an activation
current not exceeding 30 mA.
ELECTRICAL HAZARD:
Connect the power supply only
at the end of all the installation
operations. If necessary during
the installation, turn o昀昀 the
general power supply.
4. INSTALLATION 27