Table of Contents
Advertisement
1.
Press the ON key.
2.
Enter the password (if prompted) (See "Password Entry").
3.
The "PAUSE" function appears on the display.
4.
Enter into programming mode and select "OPERATING MODE". Select "CLOSED
AREA" and the words "CLOSED AREA – 60 Min" (default value) will appear on the
display.
5.
Press either the "+" or "-" key to set the minutes.
6.
Press "Enter" to confi rm.
7.
Press the "Start/Pause" key to exit the programming menu and then restart the robot.
After the set time, the robot safely stops next to the perimeter wire.
8.
Restore the normal functioning of the robot as described in chapter "INITIAL START
UP – AUTOMATIC MODE".
This mode can be executed with the remote control to mow areas with boundaries at least 15 cm high.
Important
When using the robot without the perimeter wire, make sure the robot does not run into obstacles, corners or dangerous
objects.
1.
Press the ON key.
2.
Enter the password (if prompted) (See "Password Entry").
3.
Press "Enter" to enter into programming mode. Scroll through the items until reaching "OPERATING MODE." Set the option "NO PERIMETER."
Press either the "+" or "-" key to set the working minutes of the robot.
4.
Press "Enter" to confi rm the selection.
5.
Press the "Start/Pause" key several times to exit from the menu and restart the robot.
6.
Manoeuvre the robot using the remote control.
7.
At the end of mowing, press the "OFF/STOP" key to safely stop the robot (see "Robot Safety Stop").
Important
It is recommended to move the robot with the remote control when mowing inside a narrow, well-visible area, and to make
sure there are no people or pets next to the operating zones of the robot.
The robot can be protected by a password consisting of four numbers which can be enabled, disabled and personalised by the user (see
"Programming Mode").
STARTING THE ROBOT WITHOUT THE PERIMETER WIRE
PASSWORD ENTRY
25
PAUSE
E N T E R
CLOSED AREA
60 min
E N T E R
User's manual
EN
Advertisement
Table of Contents
