Multi View - Datavideo SE-4000 Instruction Manual

4. After you've been prompted that the save is successful, reboot the SE-4000 then
physically connect the main unit and the control panel to the network or a router to
receive IP addresses assigned automatically by a DHCP server.
DHCP

2.3 Multi View

The SE-4000 Multi view output can be supplied from the HDMI or SDI outputs, see Chapter 5
(5.6) for configuring the outputs. The Multi view shows monitoring images for Preview
(PVW), Program (PGM) and Inputs 1~8. The Multi view can also show audio level bars
overlaid on the Program image. This confirms that the analogue XLR audio input is being
received and embedded to the selected Program output(s).
SE-4000 Multi-view is supplied from the HDMI connection(s) on the rear panel and available
across multiple HDMI monitors (not supplied). Since a variety of multi-image layouts is
available, these HDMI outputs can be used to monitor video and audio in a number of
different configurations. The layout of the multi view can also be changed. The sources can
be swapped around using the cross point section of the Inputs menu. For each setup,
embedded audio level indication is available on the Preview and Program windows.
See Multiviewer in Section 5.6
DHCP
for nine different multi-view layouts available on the SE-4000.
23