Table of Contents
Advertisement
AUDIO OUT
Supports two channels of the XLR
Balanced Audio output.
AUDIO IN
Supports four channels of the XLR
Balanced Audio Input.
See
Section 5.7 Audio
for audio setup.
HDMI Video Inputs 9 – 12
SDI Video Inputs 1 – 8
The HDMI inputs are
The upper row of
labelled. The numbers
SD/HD-SDI inputs are
3/4/7/8 are the respective
labelled 1~4. The lower
SDI counterparts of the
row of SD/HD SDI inputs
HDMI video inputs 9 – 12.
are labelled 5~8.
RS-232 REMOTE
Connect a custom keyboard controller to
GPI OUT
this port.
The
GPI socket
can be used for
simple external control.
See
your local Datavideo distributors.
See
Appendix 2
for more details.
SDI Video Outputs
The SDI video outputs are
user-defined outputs. Each
of these outputs has the
option to be:
Multiview
Program
Preview
Program + DSK
Clean Program
Clean Preview
Input 1 – 8
TALLY OUT
The SE-4000 Tally Output port provides bi-
colour tally information to a number of
other Datavideo products, such as the ITC-
100 eight channel talkback system or the
Datavideo TLM range of monitors.
Appendix 3
for details or contact
See
details.
HDMI Video Outputs
SYNC I/O
The SE-4000 can be
The SDI/HDMI video outputs
are user-defined. Each of
synchronized with other studio
equipment such as cameras.
these outputs has the
REF IN accepts Tri-level or
option to be:
Black Burst sync. REF LOOP can
(1) Multiview
be used to pass the sync signal
(2) Program
to other studio equipment such
(3) Preview
as cameras or recorders.
(4) Program + DSK
This function is currently under
(5) Clean Program
development.
(6) Clean Preview
(7) Input 1 – 8
11
Appendix 1
and
Section 5.6
for more
Ethernet Port
The DVIP port can be used to
connect the main unit to the
switcher's control panel or the
network.
If the DVIP port is used to
directly connect the control
panel, open the GUI and
follow the menu path Setup
Network to set the IP address.
The main unit and the control
panel can also be connected to
any network at the same time
for remote control. See
Section 2.2 Network Setup
setup instructions.
DC IN
Connect the supplied 12 V
PSU to this 4 PIN XLR
socket
Pin 1 = GND ( - )
Pin 2 = NC
Pin 3 = NC
Pin 4 = VCC ( + )
USB FW Upgrade Port
Connect the USB drive
containing the main unit's
latest firmware files to this
port and start the
firmware upgrade process
on the GUI.
Note: See
Firmware
Update
section for details.
for
Advertisement
Table of Contents
