Generator Start-Up Procedure (Auto Mode) - MQ Power WHISPERWATT Series Operation Manual

GENERATOR START-UP PROCEDURE (AUTO MODE)

STARTING (AUTO MODE)
DANGER
Before connecting this generator to any
building's electrical system, a licensed
electrician must install an isolation
(transfer) switch. Serious damage to
the building's electrical system may occur
without this transfer switch.
CAUTION
When connecting the generator to an isolation (transfer)
switch, ALWAYS have power applied to the generator's
internal battery charger. This will ensure that the engine
will not fail due to a dead battery.
NOTICE
When the generator is set to AUTO mode, the generator
will automatically start in the event of commercial
power falling below a prescribed level by means of a
contact closure that is generated automatically by a
transfer switch.
WARNING
When running the generator in AUTO mode, remember
the generator can start up at any time without warning.
NEVER attempt to perform any maintenance when the
generator is in Auto mode.
CAUTION
The engine speed switch must be set to the "High"
position when running in Auto mode. Failing to set the
switch to the proper position can result in damage to
the generator when it turns on.
NOTICE
When the Auto Start/Stop switch is placed in the AUTO
position, the engine glow plugs will be warmed and the
engine will start automatically.
PAGE 36 — DCA40SSKU4F2 60 HZ GENERATOR • OPERATION MANUAL — REV. #2 (08/30/22)
When starting the generator in AUTO mode use the
"Manual Start-Up" procedure except where noted (see
below).
1. Perform steps 1 through 5 in the Before Starting section
as outlined in the Manual Starting Procedure.
2. Place the Auto Start/Stop Switch (Figure 53) in the
AUTO position.
AUTO
OFF/RESET
Figure 53. Auto Start/Stop Switch (AUTO)
3. Continue operating the generator as outlined in the
Manual Start-Up procedure (start at step 4).
MANUAL