12 SERVICE WORK ON THE CHASSIS
12.8
12.9
64
Installing the fork legs
402556-10
V01756-11
K00546-10
Removing the lower triple clamp
Main work
–
Position the fork legs.
1
Bleeder screws
are positioned toward the front.
Info
Grooves are milled into the side of the upper end of the
fork legs. The second milled groove (from the top) must
be flush with the upper edge of the upper triple clamp.
–
2
Tighten screws
.
Guideline
Screw, top triple
clamp
–
3
Tighten screws
.
Guideline
Screw, bottom triple
clamp
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
M8
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp.
Mount and tighten screws
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
Preparatory work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
(
–
Remove front fender. (
–
Remove the handlebar cushion.
M8
20 Nm (14.8 lbf ft)
M8
15 Nm (11.1 lbf ft)
25 Nm (18.4 lbf ft)
Loctite
5
.
(
p. 103)
p. 115)
p. 116)
p. 114)
p. 61)
(
p. 102)
p. 63)
p. 69)
4
.
®
243™