12.11
Checking the steering head bearing play
Warning
Danger of accidents Incorrect steering head bearing play impairs the handling characteristic and dam-
ages components.
–
Correct incorrect steering head bearing play immediately. (Your authorized KTM workshop will be glad
to help.)
Info
If the vehicle is operated for a lengthy period with play in the steering head bearing, the bearings and the
bearing seats in the frame can become damaged over time.
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp.
Mount and tighten screws
V01792-10
Finishing work
–
Insert the fuel tank breather hose into the steering head screw.
–
Mount the handlebar cushion.
–
Install front fender. (
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
–
Check the steering head bearing for play. (
–
Remove the motorcycle from the lift stand. (
–
Check the headlight setting. (
Preparatory work
–
Raise the motorcycle with the lift stand. (
Main work
–
Move the handlebar to the straight-ahead position. Move the
fork legs to and fro in the direction of travel.
Play should not be detectable on the steering head bearing.
»
If there is detectable play:
–
Adjust the steering head bearing play.
–
Move the handlebar to and fro over the entire steering range.
It must be possible to move the handlebar easily over the
H01167-01
entire steering range. There should be no detectable detent
positions.
»
If detent positions are detected:
–
Adjust the steering head bearing play.
SERVICE WORK ON THE CHASSIS 12
M8
25 Nm (18.4 lbf ft)
bk
.
p. 69)
(
p. 103)
p. 116)
9
.
Loctite
®
243™
p. 115)
p. 67)
p. 61)
p. 61)
(
p. 68)
(
p. 68)
67