Brickwork Of The Wall - Kohler K-20629T-BW Installation Instructions Manual

3. Method four: Press from front (Front cover is reserved
access panel)
3. 安装方式四：前按扣板安装 ( 正面遮板位置为预留检修口）
Cut apart the cable tie of the air hose. Pull it out and put into
the tank.
将导气软管的扎线带剪开，导气软管抽出放入水箱。
Reserve 80±3mm gap on the wall. 7~20mm thickness is
recommended to fixate pinch. Recommended installation
hole size of L X W mm and the depth reserved of pinch
15~25mm on the back of finished wall to fixate pinch are
as follows:
墙面预留 80±3mm 深的避位，扣板安装厚度建议
7~20mm，扣板安装的建议安装孔 L X W (mm)，完工墙
内侧预留扣板安装深度 15~25mm，见如下尺寸及适配面
板型号：
+2 +2
LXW: 201 X 136
0 0
K-20341T-PNE
K-75890T-PNE
Note: No direct contact between the faceplate and the tank.
注： 面板与水箱不直接接触。
1E. Brickwork of the wall
1E. 砌墙
1. Protection of inlet hole and drainage hole
1. 进、排水口防护
As shown, tighten the long screw into the holes of the tank
bracket and cover the drainage hole with the big cap, cover
the inlet hole with the small cap.
Note: 1. The screw head ' 一 ' slot is facing outward.
2. Install screw protective hose, do not remove it
before installing the toilet.
如图将长螺杆旋入水箱架的螺丝孔上，再将大防物盖装在排
污口上，小防物盖装在进水口上。
注： 1. 螺杆一字头朝外。
2. 螺杆防护套安装好，安装座便器前不要取下来。
1402749-K2-A
mm:
K-24149T K-75891T-PNE
K-24151T
It is suggested that the thickness of tank +
decorative surface 80 ± 3mm
建议水箱+装饰面的厚度 80 ± 3mm
Pinch
扣板
Air Hose
导气软管
Inlet Hole
进水口
Drainage Hole
排污口
-15-
Recommended
thickness of
decorative board
7~20mm
建议装饰板厚度
7~20mm
It is recommended to
reserve the installation
height of the pinch
15~25mm
建议预留扣板安装高度
W
15~25mm
Faceplate
面板
Locking Plate
定位板
Finished Decorative
Surface
完工装饰面
L
W
Tank Bracket
水箱架
Small Cap
小防物盖
Long Screw
长螺杆
Big Cap
大防物盖