Get Started; Attach The Power Cord - SATO Argox D2-250 User Manual

2 Get started

2 Get started
This chapter describes how to set up your printer.
Caution Do not use your printer in areas exposed to splashing water or
any other liquid.
Caution Do not drop your printer, or place it in an area subject to
humidity, vibration or shock.

2.1 Attach the power cord

1. Make sure the power switch is set to the OFF position.
2. Insert the power supply's connector into the printer power jack.
3. Insert the AC power cord into the power supply.
4. Plug the other end of the AC power cord into the wall socket.
Important Use only power supplies listed in the user instructions.
Warning Do not plug the AC power cord with wet hands, or operate the
printer and the power supply in an area where they may get wet. Serious
injury may result from these actions!
10
Attach the power cord