SATO Argox D2-250 User Manual page 32

3 Printer operation Self Test
28. Reprint After Error
When it is enabled, your printer reprints the label after the error fixed if it is
printed incorrectly due to the error.
29. Backfeed Enabled/Disabled
Enable or disable backfeed during the printing process. When it is enabled,
the printer moves the paper forward in a predefined length 1 second after
printing, and pulls the paper back in a predefined length once the printing
begins again. When it is disabled, the printer won't move the paper at all.
30. Cutter Enabled/Disabled
Enable or disable the cutter during the printing process.
31. Peeler Enabled/Disabled
Enable or disable the dispenser during the printing process.
32. Cutter/Peeler Offset
Move the cutting line or the peeling position forward or backward. The
value in the angle brackets is the offset unit.
33. Product SN
Display printer serial number.
34. USB SN
Display printer USB host serial number.
35. CG Enable
Printer is able to use True Type font.
36. EMU Auto
Printer is in the Auto Emulation mode
37. TPH and Cutter Offset
This is for developers to debug.
38. Reflective Sensor Gap Calibration
This is for developers to debug.
39. See-Through Sensor Gap Calibration
This is for developers to debug.
40. Reflective Sensor Profile
This is for developers to debug.
41. See-Through Sensor Profile
This is for developers to debug.
42. Ribbon Voltage Delta
26