SATO Argox D2-250 User Manual page 31

3 Printer operation Self Test
Printing speed unit is inch per second (ips).
17. ABS. Darkness
Display the current darkness. You can use the PPLZ command ~SD to define
it.
18. Trim. Darkness
Display the adjustment of the current darkness. You can use the PPLZ
command ^MD to define it.
19. Print Method
It is either thermal transfer (TT) or direct thermal (DT) printing. TT requires
ribbons and DT doesn't.
20. Print Length
Display total print length.
21. Cut Count
It counts the times the cutter cuts.
22. Caret Control Char
The control character your printer is using.
23. Delimiter Control Char
The control character your printer is using.
24. Tilde Control Char
The control character your printer is using.
25. Code page
The character set table.
26. Media
The media type in use.
27. Calibration mode
There are Intelli Mode and Smart Mode.
Intelli Mode: Just install labels, latch print module, press FEED button once,
and then the printer will feed 1-2 labels to detect next gap / black mark
before printing. The printer will feed 1-2 labels automatically before printing,
if FEED button is not pressed.
Smart Mode: Print from the first label immediately according to label length
setting. Make sure to carefully align label bottom edge at the tear-off
position before printing.
25