Get Started; Attach The Power Cord - SATO Argox XM4 Series User Manual

XM4 Series Printer
User Manual

2 Get started

This chapter describes how to set up your printer.

2.1 Attach the power cord

1. Ensure the power switch is set to the OFF position.
2. Place the printer within cable distance of the host and printer (using a
USB or serial cable).
3. Keep the power cord isolated from other electrical cables.
4. Plug one end of the AC power cord into the power socket on the printer.
The power socket is located on the back of the printer.
5. Plug the other end of the AC power cord into a wall outlet. Make sure
the wall outlet and the printer have the same voltage and frequency,
otherwise you may damage or explode the printer.
Warning Do not plug the AC power cord with wet hands, or operate
the printer and the power supply in an area where they may get wet.
Serious injury may result from these actions!
9