Table of Contents
Advertisement
3-10. Tilting the sewing machine head
WARNING :
Tilt/raise the sewing machine head with both hands taking care not to allow your fingers to be caught
in the head. Turn OFF the power before starting the work so as to prevent accidents caused by abrupt
start of the sewing machine.
❶
❷
3-11. Installing the operation panel
❷
❶
When tilting the sewing machine head, tilt the head
gently until it comes in contact with head support rod
❶ .
Fix operation panel mounting plate ❶ on the table
with four wood screws ❷ . Then, pass the cable
through hole ❸ in the table.
❸
In the case of installing the operation panel on the
undersurface of the table, install the operation panel
❶
on panel mounting plate ❶ by tightening screws ❹
❹
in four mounting holes. Then, fix the panel mounting
plate at a desired position on the undersurface of the
table with four wood screws ❷ .
❷
－
－
9
1. Before tilting the sewing machine head,
make sure that head support rod ❶ is
attached to the machine table.
2. When raising the sewing machine
head, do not raise it while holding
motor cover ❷ . It will be the cause of
breakage of motor cover ❷ .
3. Be sure to tilt the sewing machine head
on a flat place to prevent it from falling.
Advertisement
Table of Contents
