JUKI LK-1900S-SS Instruction Manual page 72

Error code Indication
E043 Enlargement error
The sewing pitch is beyond 10 mm.
E045 Pattern data error
The pattern data cannot be adopted.
E050 Temporary stop
Temporary stop by operating the reset
key while the sewing machine is running.
(Refer to memory switch No. 31.)
E061 Memory switch data error
Memory switch data is broken or revision
is old.
Machine head identification error
E063
The type of machine head and the type of
control box do not match.
E204 Connection alert for the USB thumb
drive which is used for sewing
Sewing has been carried out by 10 or
more times with the USB thumb drive in-
serted in the USB port.
E220 Grease replenishing time information
Information as to the time of replenishing
the designated places with grease
Refer to
nated places with grease"
E221 Grease replenishing warning error
Sewing machine has stopped since the
time of replenishing the designated plac-
es with grease has come.
Refer to
nated places with grease"
E302 Head tilt error
Head tilt detection switch is turned OFF.
E303 Z phase detection error
Detection of the upper dead point of the
sewing machine cannot be performed.
E305 Thread trimmer position error
The thread trimmer is not in the proper
position.
Description of error
"I.7-9. Replenishing the desig-
p.56.
"I.7-9. Replenishing the desig-
p.56.
－ －
70
Corrective measure
P r e s s t h e r e s e t k e y a n d
check the pattern and X/Y
scale rate.
Re-operation is enabled after
resetting.
Re-start or return-to-ori-
gin after thread trimming
by means of the reset key
(For the details, refer to the
item "I.6-4. How to use the
temporary stop" p.37.)
Re-operation is enabled after
resetting.
Turn the power OFF and
contact JUKI or your distribu-
tor.
Re-operation is enabled after
resetting.
Replenish the designated
places with grease and set
memory switch No. 245 to
"0" with the RESET key. Er-
ror can be released with the
RESET key when immediate
replenishing with grease
cannot be performed during
sewing operation.
Immediately perform replen-
ishing with grease and set
memory switch No. 245 to "0"
with the RESET key.
The sewing machine cannot
be operated with the head
tilted. Return the sewing
machine head to its proper
position.
Turn OFF the power switch.
Check whether the pin of the
SDC board CN15 has come
off or has loosened.
Turn OFF the power switch
and check whether CN72
has come off or has loos-
ened.
Remarks