Error List - JUKI LK-1900S-SS Instruction Manual

9-5. Error list

Error code Indication
E007 Machine lock error
The main shaft of the sewing machine
does not rotate due to some troubles.
E010 Pattern No. error
Back-uped pattern No. has not been
registered in the data ROM, or it is set to
readout inoperative.
Pattern No. is set to "0".
E011 External media not inserted
USB thumb drive is not inserted.
E012 Read error
Data cannot be read from the USB thumb
drive.
E013 Write error
Data cannot be written on the USB thumb
drive.
Write-protect
E014
USB thumb drive is write-protected.
E015 Format error
USB thumb drive cannot be formatted.
E016 External media capacity over
Memory capacity of the USB thumb drive
to write pattern data is not sufficient.
E017 Machine memory capacity over
Memory capacity of the sewing machine
to write pattern data is not sufficient.
E019 File size over
The pattern data to be read from the USB
thumb drive is too large. (Max.: Approxi-
mately 20000 stitches)
E022 File No. error
There is no designated file in the external
media.
Pattern data size over
E024
The pattern data to be written on the sew-
ing machine memory is too large. (Max.:
Approximately 20000 stitches)
E030 Needle bar position error
Needle bar is not in the specified position.
E040 Travel limit error
The dimensions of the sewing pattern ex-
ceed the travel limit range
Description of error
－ －
69
Corrective measure
Turn OFF the power switch
and remove the cause of
troubles.
P r e s s t h e r e s e t k e y a n d
check the pattern No.
Check the contents of mem-
ory switch No. 201.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Possible to recover by reset.
Re-operation is enabled after
resetting.
Turn the hand pulley to re-
turn the needle bar to its
specified position.
Press the RESET key. Then,
check the X/Y scale and di-
mensions of the pattern.
Remarks
Previous
screen
Press the
RESET key.
Then, check
the X/Y
scale and di-
mensions of
the pattern.