Table of Contents
Advertisement
(3) Sewing operation
Operation example : After performing sewing with the contents of the registered P2, perform sewing with
⇩
⇩
⇔
➡
⇩
⇩
⇔
➡
the contents of P3.
1) Turn ON the power switch.
2) Press direct pattern
3) Press READY key
LED . Once the LED lights up, the work clamp
goes up after traveling.
4) Check the contour of the sewing pattern.
(Refer to the item
of a sewing pattern"
5) If the contour of the sewing pattern is acceptable,
the sewing can be made.
6) After the completion of sewing, press direct pat-
tern
. Then, the work clamp comes down,
retrieves the origin, travels to the sewing starting
point and goes up. Then, the origin is retrieved.
After the origin retrieval, the work clamp travels
to the sewing starting point and goes up.(The P
keys can operate the pattern change by one-touch
even when the SET READY LED is lighting up.)
7) Perform the above items 4) and 5).
* P1 to P25 can be specified by selecting the
pattern. Display the target pattern using DATA
CHANGE key
→ 0 to 200 ←→ P1 to 25 ←
P1 to P25 which have not been registered are not
indicated.
Press P1 to P25 key while the SET READY
LED lights up and the presser comes
down. Be careful that your fingers are not
caught in the presser.
Pattern register from P26 to P50 can be
performed. Register can not be performed
in
to
by the pattern selection only. Indicate the
pattern with
→ 0 to 200 ←→ P1 to P25 ←→ P26 to P50 ←
Pattern selection from P26 to P50 cannot
be performed while the SET READY LED
lights up.
－
－
30
.
to light up SET READY
"I.5-4. Checking the contour
p.21.)
.
key. Designate the pattern
key.
Advertisement
Table of Contents
