Table of Contents
Advertisement
To exit the active DTC(s) alarm section, press the ↑ and ↓ buttons simultaneously to enter the navigation menu. Once
entered, cycle to the desired operator screen.
Icon
Check Engine Fault
Low Oil Pressure
Under Speed
Over Speed
Low Fuel Level
Battery Under/Over Voltage
EVENT LOG
The controller's Event Log displays a list of the last 15 recorded electrical trip or shutdown events and the engine
hours at which they occurred. Once the log is full, any subsequent electrical trip or shutdown alarm overwrites the
oldest entry in the log. Hence, the log always contains the most recent shutdown alarms.
To view the Event Log, press both ↑ and ↓ buttons simultaneously, the navigation menu is then displayed. Once
entered, cycle to the Event Log section and press the Auto button to enter. Repeatedly press the ↑ or ↓ buttons until
the LCD window displays the desired event.
Continuing to press down the ↑ or ↓ buttons will cycle through the past alarms after which the display shows the most
recent alarm and the cycle begins again.
To exit the Event Log, press the ↑ and ↓ buttons simultaneously to enter the navigation menu. Once entered, cycle
to the desired operator screen.
PRESTART CHECKLIST
Before starting the unit, all items in the prestart checklist must be completed.
Read and understand ALL safety sections at the beginning of this manual.
Ensure all maintenance procedures are up to date. For more information, refer to
Maintenance" on page 33
The unit must be level.
The unit must be dry. Check for any water inside, on, or near the unit; dry if needed.
Ensure the unit is properly grounded to a good earthen ground. Installation should be in compliance
with the National Electrical Code (NEC), state and local regulations.
Switch the Control Power switch to the OFF (O) position.
Switch all circuit breakers to the OFF (O) position.
Inspect all electrical cords; repair or replace any that are cut, worn, or bare.
Ensure all winch cables are in good condition and centered on each pulley. Do not use if cables are
kinked or beginning to unravel.
Check oil, coolant, and fuel levels. For more information, refer to
Ensure engine battery connections are secure.
Turn the battery disconnect switch on, if equipped.
Check the engine fan belt tension and condition.
Check the engine fan belt guard.
Check the engine exhaust system for loose or rusted components.
Fault
The engine ECU has detected a fault not recognized by the con-
troller, contact the engine manufacturer for support.
The engine ECU has detected that the engine oil pressure has
fallen below its configured low oil pressure alarm level.
The engine ECU has detected that the engine speed has fallen
below its configured under speed alarm level.
The engine ECU has detected that the engine speed has risen
above its configured over speed alarm level.
The engine ECU has detected that the engine's fuel level has
fallen below its configured low fuel level alarm.
The engine ECU has detected that the engine's DC supply has
fallen below or risen above its configured alarm level.
and Basic Maintenance Schedules beginning on
DTC Description
"General
page
33.
"General Maintenance" on page
33.
23
Advertisement
Table of Contents
