Generac Power Systems MAGNUM MLT4200IF4V Operating Manual page 30

2. Push the ↑ button until the wrench (
3. Change the parameter number to enable the desired timer. When the correct parameter number is showing,
press the Auto button to enter it. Press the Manual/Start (I) button to change it to 1 to enable the timer and press
the Auto button to save it.
Note: The ↑ and ↓ buttons will adjust the hundredths place of the parameter number and the Manual/Start (I) and
Stop/Reset (O) buttons will adjust the low digits. Up to eight events can be scheduled at a time.
4. Change the parameter number to adjust the time of the desired event and then press the Auto button to enter
it. Press the Manual/Start (I) and Stop/Reset (O) buttons to change the time. Holding down either button will
change the time faster. Press the Auto button to save the time.
5. Change the parameter number to adjust the day of the week and press the Auto button to enter it. Press the
Manual/Start (I) and Stop/Reset (O) button to change to the desired day and press the Auto button to save it.
Note: Only one day can be chosen per event if parameter 903 is "1" (monthly).
6. Change the parameter number to adjust duration of the timer and press the Auto button to enter it. Press the
Manual/Start (I) or Stop/Reset (O) buttons to change the duration and press the Auto button to save it.
Note: If any of the scheduled time slots are currently active, the controller will begin the starting sequence and start
the unit, provided there are no shutdown conditions present.
The times for the scheduled timers/events are based on the internal clock for the controller. Use the corresponding
parameters to adjust to the correct time of the day and correct date.
This table lists the parameters needed to schedule an event and to adjust the clock within the controller.
Note: If parameter 902 is "0", then the auto exercise timer is enabled, and if it is "1", then the autolight timer is enabled.
Parameter
901 Enable Scheduler
902 Schedule Run On or Off Load
903 Schedule Period
904 Scheduler (1) Start Time
905 Scheduler (1) Start Day
906 Scheduler (1) Start Week
907 Scheduler (1) Duration
908 Scheduler (2) Start Time
909 Scheduler (2) Start Day
910 Scheduler (2) Start Week
911 Scheduler (2) Duration
912 Scheduler (3) Start Time
913 Scheduler (3) Start Day
914 Scheduler (3) Start Week
915 Scheduler (3) Duration
916 Scheduler (4) Start Time
917 Scheduler (4) Start Day
918 Scheduler (4) Start Week
919 Scheduler (4) Duration
) icon is selected. Push the Auto button to enter the parameters.
Description
Configuration Parameters - Scheduler
Details
On (1), Off (0)
On (1), Off (0)
Weekly (0), Monthly (1)
0:00:00
0 (1=Monday)
1,2,3,4
0:00:00
0:00:00
0 (1=Monday)
1,2,3,4
0:00:00
0:00:00
0 (1=Monday)
1,2,3,4
0:00:00
0:00:00
0 (1=Monday)
1,2,3,4
0:00:00
29