Table of Contents
Advertisement
6. Make sure the mast cradle locking pin is in place.
7. Make sure the doors are properly latched.
8. If the unit is going to be driven over rough ground, remove the bulbs from the light fixtures.
9. Check for proper inflation of the trailer tires. Refer to
10. Check the wheel lugs. Tighten or replace any lugs that are loose or missing. If a
tire has been removed for axle service or replaced, tighten the lugs, in the order
shown, to the following specifications:
A. Start all lug nuts by hand.
B. First pass tighten to 20-25 ft-lbs (27-33 Nm).
C. Second pass tighten to 50-60 ft-lbs (67-81 Nm).
D. Third pass tighten to 90-120 ft-lbs (122-162 Nm).
Note: After the first road use, re-torque the lug nuts in sequence.
11. Maximum recommended speed for highway towing is 45 mph (72 km/h). Recommended off-road towing speed
is not to exceed 10 mph (16 km/h) or less, depending on the terrain.
LIFTING THE UNIT
When lifting the unit, attach any slings, chains or hooks
directly to the central lift point. The central lift point is
located on the mast between the two upper forklift pock-
ets.
1. Make sure the equipment being used to lift the unit
has sufficient capacity. For approximate weights,
refer to Specifications beginning on
2. Always remain aware of people and objects around
the unit while moving.
3. Use the upper or lower forklift pockets with care.
Approach the unit as perpendicular as possible to
avoid any damage to the unit. Make sure all obstruc-
tions are clear of the forklift tines before lifting.
32
"Specifications" on page
page
9.
9.
1
4
3
2
5
Central
Lift Point
Upper
Forklift
Pockets
Lower
Forklift
Pockets
00922
00204
Advertisement
Table of Contents
