Printronix P5000 Series Setup Manual page 134

Chapter 5
VMS Operating System
When using the serial interface with the VMS operating system, configure the
terminal characteristics with the SET TERM command, as shown below:
Terminal: _TXA3: Device_Type: Unknown Owner: SYMBIONT_0001
Username: SYSTEM
Input: 9600*
Output: 9600*
Terminal Characteristics:
Interactive Echo
No_Hostsync TTsync
No_Wrap Scope
No_Broadcast No_Readsync
No_Modem No_Local_echo
No_Brdcstambx No_DMA
Line_Editing Overstrike_editing
No_Secure_server No_Disconnect
No_SIXEL_Graphics No_Soft_Characters
No_ANSI_CRT No_Regis
No_Edit_mode No_DEC_CRT
Device spooled to _DUAL:
* Match baud rate to printer settings.
** When using the Line Printer Plus emulation, the input width is 136.
134
LFfill: 0 Width: 132** Parity: None
CRfill: 0 Page: 66
Type_ahead
Lowercase
No_Remote
Form
No_Autobaud
No_Altypeahd
No_Fallback
No_Pasthru
No_Printer_Port
No_Block_mode
No_DEC_CRT
No_Escape
Tab
No_Eightbit
Fulldup
No_Hangup
Set_speed
No_Dialup
No_Syspassword
Numeric_Keypad
No_Advanced_video