Table of Contents
Advertisement
Note:
3.4.1
Configuring Basic H.248 Parameters
After accessing the Embedded Web Server (refer to Section
Setup' screen is displayed, shown in
To configure basic H.248 parameters, take these 16 steps:
1.
If your network features a DNS server, in the fields 'DNS Primary Server IP' and 'DNS
Secondary Server IP', enter the IP address of the primary and secondary DNS servers
(clarify with your network administrator).
2.
If your network features a DHCP server, in the 'Enable DHCP' field, select 'Enable'; the 'IP
Address', 'Subnet Musk' and 'Default Gateway IP Address' fields are disabled. When the
gateway is configured to use DHCP, it attempts to contact the DHCP server to obtain the
networking parameters (e.g., IP address, subnet mask, default gateway and
primary/secondary DNS server).
H.248/SIP
The following configuring Sections from here up to and including Section
3.4.2
on page
26
apply individually to H.248 OR SIP.
H.248 Configuring continues with Section
SIP Configuring continues with Section
Figure
Figure 3-3: MG 3200 H.248 Quick Setup Screen
3.4.1
3.4.2
on page 26.
3.3
3-3.
24
Media Gateway 3200
below.
on page 23) the H.248 'Quick
Document #: LTRT-73805
Advertisement
Table of Contents
