Table of Contents
Advertisement
Fast Track Installation Guide
5.
Configure 'Enable Registration' to 'Yes' or 'No':
'No' = the MG 3200 does not register to a Proxy server/Registrar (default).
'Yes' = the MG 3200 registers to a Proxy server/Registrar at power up and every
'Registration Time' seconds. For detailed information on the parameter 'Registration Time'
refer to the MG 3200 SIP User's Manual.
6.
Select the coder (i.e., vocoder) that best suits your VoIP system requirements. The default
coder is: G.7231 30 msec. To program the entire list of coders you want the MG 3200 to use,
click the button on the left side of the '1
coders appear. Select coders according to your system requirements. Note that coders
higher on the list are preferred and take precedence over coders lower on the list.
Note:
7.
Map outgoing calls to IP addresses (when Proxy isn't used) by completing these steps:
Click the arrow button next to the 'Tel to IP Routing Table' label; the 'Tel to IP Routing'
screen opens.
Any telephone number whose destination number matches the prefix defined in the
'Destination Phone Prefix' field and whose source number matches the prefix defined in
the adjacent 'Source Phone Prefix' field, is sent to the IP address entered in the 'IP
Address' field.
Click the Submit button; the 'Tel to IP Routing' table is automatically updated.
Click the Close Window button.
For more information on the 'Tel to IP Routing' table refer to the SIP MG 3200 User's
Manual.
8.
Enable E1/T1 B-channels by completing these steps:
Click the arrow button next to the 'Trunk Group Table' label; the 'Trunk Group Table'
screen opens.
Select the number of the trunk you want to enable from the 'Trunk ID' drop-down list.
Enter the number of B-channels you want to enable in the 'Channels' field.
Enter the starting phone number in the adjacent 'Phone Number' field (these are virtual
numbers, used only to define enabled B-channels).
Click the Submit button; the 'Trunk Group Table' table is automatically updated.
Click the Close Window button.
9.
Click the Reset button and click OK in the prompt; The MG 3200 applies the changes and
restarts. This takes approximately 3 minutes to complete. When the MG 3200 has finished
restarting, the Ready and LAN LEDs on the front panel are lit green.
10.
After the gateway is reset, configure the MG 3200 trunk parameters. For information on
configuring the trunk parameters, refer to Section
Note:
Version SN09
The preferred coder is the coder that the MG 3200 uses as a first choice for
all connections. If the far end gateway does not use this coder, the MG 3200
negotiates with the far end gateway to select a coder that both sides can use.
SIP Users should continue with Section
page 28.
st
Coder' field; the drop-down lists for the 2
3.5
on page 28.
3.5 Configuring the Trunk Settings
27
3. Configuring the MG 3200
nd
th
to 5
August 2005
on
Advertisement
Table of Contents
