1. Remove screws A at the front of legrest.
2. Remove cover together with calf pads.
3. Loosen nuts B at the side of legrest.
It may be necessary to remove the nuts and move them
from one slot to the other.
4. Set desired length.
5. Retighten nuts.
6. Refit the calf pads and cover and retighten screws.
The legrest with foot platform is adjusted the same
way.
5.12.2 Setting Angle of Foot Plate
•
5/32 inch Allen key
1578997-N
1. Fold the foot plates up in order to access the adjusting
screws (1).
2. Set the adjusting screws using the Allen key.
3. Fold the foot plate down again.
5.12.3 Setting Angle of Footboard
•
5/32 inch Allen key
1. Fold the foot platform up in order to access the
adjusting screw A.
2. Set the adjusting screw using the Allen key.
3. Fold the foot platform down again.
Fig. 5-28
Fig. 5-29
Setup
51