Electrical Connection - Miele PW 6163 Operating And Installation Instructions

Use connections 1 and 2 for viscous agents or for high-pressure
dispensing systems with water injection. The dispensing systems
must comply with all relevant local and national regulations and be
fitted with suitable backflow prevention. The maximum flow rate is
1500 ml/min at a maximum water connection pressure of 300 kPa.
These connectors are sealed and need to be drilled open using an
8 mm drill bit before connecting.
Make sure that you only drill through the first panel (I) as there is a
deflecting panel (II) 10 mm behind it.
Connections 3 to 12 are provided for liquid detergent. High pressure
dispensing systems with water injection must not be connected to
these connections. The connectors are sealed and must be cut to the
diameter of the hose with a small saw before they are connected.
Connectors that are no longer required must be resealed using a
suitable sealant (e.g. silicone).
Up to 4 time-controlled dosing pumps can be operated without
multifunction module. The connection terminals are located behind
the cover next to the electrical connection. See enclosed wiring
diagram.
Calibration of the dispenser pumps and regulation of dispensing
quantities is carried out partly automatically for washing machines
fitted with an optional multifunction module.
A flowmeter or throughput sensors can be connected for precise
monitoring of the dispensing quantity.
Connections for level monitoring are available for every agent
dispensed.

Electrical connection

The electrical connection must be carried out by a qualified
electrician who must ensure that all electrical work is carried out in
accordance with applicable electrical regulations and standards.
This washing machine must be connected to an electrical mains
supply that complies with local and national regulations. Please also
observe your insurance and energy supplier's regulations as well as
any workplace health and safety regulations.
Installation
79