Table of Contents
Advertisement
3
Package content
- Natural Convection Pellet Stove "Stanley Lir" 5 kw
- Side covers, Top cover, Top and bottom front cover
- Instruction Manual, Power cable & M10 Feet
3.1.1
Unpacking the Stove
To unpack the unit, remove the cardboard box. Then remove the plastic wrap that is around the stove and the bag. To complete the
procedure, unscrew the four screws that secure the unit to the wood pallet
4
Safety precautions
Waterford Stanley is not liable for any damages to the stove if the specified precautions, warnings and operating procedures
are not followed.
Waterford Stanley stoves are easy to operate and special attention was given to their components in order to protect users and
installers against accidental damages.
The stoves must only be installed by a qualified installer, who should supply the client with a relevant statement of conformity
and who shall be liable for the final installation and consequent product good operating conditions.
This stove must be used according to its intended use as specified by the manufacturer. The manufacturer is excluded from
all liability, by contract or by tort, caused by injury to people, animals or property arising from misuse or faulty installation or
servicing.
After removing the packaging, verify the contents to check their integrity and completeness. If the content of the package
fails to correspond to that indicated in point 1, contact the retailer from whom you purchased the stove.
All the stove's components guarantee its operation and energy efficiency and should only be replaced with original parts
provided by an authorised Stanley retailer or service engineer.
The stove should be serviced at least once a year by the Stanley service engineer or more frequently depending on
usage of pellets. This manual is provided with the product. Please keep it close to the stove.
Figure 1 – Unpacking the unit
Page 5 of 28
Advertisement
Table of Contents
