Service; It's Becoming Too Hot In The House - Stanley Lir LIR500 Installation And Operating Instructions Manual

13.1.6

'Service'

This report indicates that the stove has been worked for 1200 hours. The stove indicates this as a reminder that
maintenance must be carried out.
Reading and resetting operating hours
Enter the Testing menu by pressing SET and the Power Plus Button
for more than 5 seconds.
The stove now displays 'TEST COMPONENTI'. Press SET
To determine the number of hours your stove has been burning. Read the total amount of operating hours under Ore Lav.
These hours cannot be reset. Find the Work hours Service Interval under Da Ass. If this amount exceeds 1200, the pellet stove
displays a service message. Following maintenance, reset the service message in this menu as follows:
Simultaneously press and hold both temperature buttons until the
The service message disappears from the display.
Note! Press the right buttons! Simultaneously pressing the power buttons will cause the parameters to reset to the
settings of the software manufacturer. These settings are completely different from the pellet stove parameters.
13.1.7

It's becoming too hot in the house

The temperature in the house rises further than you have set. This may have several causes:
The stove has too much power in P1. Usually means that there is nothing wrong with the stove. You have set the
-
stove at 20°C for example, but the temperature rises much further. Check whether the stove actually modulates
back to P1. Keep in mind that a pellet stove produces about 3kW of heat in the lowest position. This means that in
a small and/or well insulated room, the temperature will continue to rise as long as you leave the stove on. If you
do not want the temperature to rise any further, make sure there is sufficient ventilation or switch the stove off.
The room temperature sensor is measuring a very low temperature so the stove doesn't stop working in high
-
Power. If it is placed on the floor or against the wall, it measures the temperature of the wall or the floor instead of
the room temperature.
The room temperature sensor malfunctions. If this is the case, the stove will not properly read the temperature and
-
respond accordingly.
hours jump to 00000.
Page 23 of 28