Voice Vlan - Planet Networking & Communication SGS-5240 Series User Manual

◆Interface – Displays a list of ports or groups.
◆Port – Port Identifier. (Range: 1-28)
◆Group – Group Identifier. (Range: 1-12)
◆Mode – Sets the VLAN membership mode of the port.

None – The port operates in its normal VLAN mode. (This is the default.)

Access – Configures QinQ tunneling for a client access port to segregate and preserve customer VLAN IDs for
traffic crossing the service provider network.

Uplink – Configures QinQ tunneling for an uplink port to another device within the service provider network.
Use the Configure Global page to set the switch to QinQ mode before configuring a QinQ access port or tunnel uplink port.

4.2.4.9 Voice VLAN

Switch Management > VLAN >Voice Vlan>Status page is used to configure the voice vlan.
VLAN membership cannot be set to access mode.

Status
 Auto Detection Status – Enables the automatic detection of VoIP traffic on switch ports. (Default: Disabled)
 Voice VLAN – Sets the Voice VLAN ID for the network. Only one Voice VLAN is supported and it must already be created
on the switch. (Range: 1-4094)
 Aging Time – The time after which a port is removed from the Voice VLAN when VoIP traffic is no longer received on the
port.
(Range: 5-43200 minutes; Default: 1440 minutes)
Note: The Voice VLAN ID cannot be modified when the global Auto Detection Status is enabled.

OUI
Switch Management > VLAN > Voice Vlan > OUI page is used to configure the Organizational Unique Identifier (OUI) in the
source MAC address of received packets.
User's Manual of SGS-5240 Series Managed Switch
66