Web Authentication; Global Configuration; Interface Configuration; Host List - Planet Networking & Communication SGS-5240 Series User Manual

4.7.2 Web Authentication

4.7.2.1 Global Configuration

Security > Web Authentication > Global Configuration page is used to edit the global parameters for web authentication.
 Web Authentication Status – Enables web authentication for the switch. (Default: Disabled)
Note that this feature must also be enabled for any port where required under the Configure Interface menu.
 Session Timeout – Configures how long an authenticated session stays active before it must re-authenticate itself.
(Range: 300-3600 seconds; Default: 3600 seconds)
 Quiet Period – Configures how long a host must wait to attempt authentication again after it has exceeded the maximum
allowable failed login attempts. (Range: 1-180 seconds; Default: 60 seconds)
 Login Attempts – Configures the amount of times a supplicant may attempt and fail authentication before it must wait the
configured quiet period. (Range: 1-3 attempts; Default: 3 attempts)

4.7.2.2 Interface Configuration

Security > Web Authentication > Interface Configuration page is used to configure the interface.

4.7.2.3 Host List

Security > Web Authentication > Host List page is used to show the Host information.
User's Manual of SGS-5240 Series Managed Switch
218