Mac Notification - Planet Networking & Communication SGS-5240 Series User Manual

4.2.5.3 MAC Notification

Switch Management > MAC Address > MAC Notification page is used to send SNMP traps (i.e., SNMP notifications) when a
dynamic MAC address is added or removed.
■ Configure Global
◆ Trap Status – Issues a trap when a dynamic MAC address is added or removed. (Default: Disabled)
◆Trap Interval – Specifies the interval between issuing two consecutive traps. (Range: 1-3600 seconds; Default: 1 second)
◆ Port – Port Identifier. (Range: 1-28/52)
Configure Interface
◆Trap Status – Enables MAC authentication traps on the current interface. (Default: Disabled)
MAC authentication traps must be enabled at the global level for this attribute to take effect.

Configure Interface
To enable MAC address traps at the global level:
1. Click Switch Management, MAC Address, MAC Notification.
2. Select Global from the Step list.
3. Configure MAC notification traps and the transmission interval.
4. Click Apply.
User's Manual of SGS-5240 Series Managed Switch
73