Igmp Filtering And Throttling; Global Setting; Filter Profile - Planet Networking & Communication SGS-5240 Series User Manual

User's Manual of SGS-5240 Series Managed Switch

4.2.12 IGMP Filtering and Throttling

4.2.12.1 Global Setting

Switch Management > IGMP Filtering and Throttling>Global Setting page is used to enable IGMP filtering and throttling globally
on the switch.
◆IGMP Filter Status – Enables IGMP filtering and throttling globally for the switch. (Default: Disabled)

4.2.12.2 Filter Profile

Switch Management > IGMP Filtering and Throttling>Filter Profile page is used to create an IGMP profile and set its access
mode. Then use the (Add Multicast Group Range) page to configure the multicast groups to filter.
◆Profile ID – Creates an IGMP profile. (Range: 1-4294967295)
◆Access Mode – Sets the access mode of the profile; either permit or deny. (Default: Deny) When the access mode is set to
permit, IGMP join reports are processed when a multicast group falls within the controlled range. When the access mode is set
to deny, IGMP join reports are only processed when the multicast group is not in the controlled range. Add Multicast Group
◆Profile ID – Selects an IGMP profile to configure.
Range
◆Start Multicast IP Address – Specifies the starting address of a range of multicast groups.
◆End Multicast IP Address – Specifies the ending address of a range of multicast groups.
118