Table of Contents
Advertisement
4.3 Setting 1000BASE-X for 10G SFP+ Port
The Managed Switch supports both 1000BASE-X and 10GBASE-X SFP
transceivers by manual setting and the default SFP+ port speed is set in the fiber
auto mode, so the end-user can plug the transceiver directly.
In another example, the end-user has to force the fiber connection with
1000BASE-X SFP transceiver in the tgigaethernet 0/1. The following command
configuration is required:
Switch#config
Switch_config#interface TGigaEthernet0/1
Switch_config_tg0/1#no fiber-auto-config
Switch_config_tg0/1#speed 1000
Switch_config_tg0/1#exit
4.4 Changing Password
The default password of the switch is "admin". For security reason, it is
recommended to change password and the following command configuration is
required:
Switch#config
Switch_config#username admin password planet2022
Switch_config#
4.5 Saving the Configuration
In Managed Switch, the running configuration file stores in the RAM. In the current
version, the running configuration sequence running-config can be saved from the
RAM to FLASH by write command, so that the running configuration sequence
becomes the start-up configuration file, which is called configuration save.
Switch#write
Switch#write
Saving current configuration.
OK!
Switch#Jan 2 00:56:04 /startup-config is wrote, TID:85bd29c0
Figure 4-6 Setting 1000BASE-FX Screen
Figure 4-7 Changing Password Interface Screen
Figure 4-8 Write Screen
9
Advertisement
Table of Contents
