Mounting The 8010Co Chassis In A Hendry Rack; Figure 33 Installing The Installation Shelf In A Hendry Rack - Nortel Passport 8000 Series Installing And Maintaining

Mounting the 8010co Chassis in a Hendry rack

To install the 8010co Chassis in a Hendry rack:
1 Place the installation shelf at the bottom of the rack.
2
Holding the installation shelf in position, align the shelf's mounting rail with
two holes on each side of the vertical rack support.
3
Insert a hex head screw through each installation shelf mounting hole and into
the corresponding hole in the rack

Figure 33 Installing the installation shelf in a Hendry rack

3
2
1 = Hex head screws (x4)
2 = Installation shelf
3 = Hendry equipment rack
4 Tighten each screw with a nutdriver.
5 Using a Phillips screwdriver, remove the 5 screws securing each of the two
mounting rails to the 8010co Chassis
Chapter 3 Installing the 8010co Chassis 61
(Figure
1
(Figure
Installing and Maintaining the Passport 8000 Series Chassis
33).
34).
10402FB