68 Chapter 3 Installing the 8010co Chassis
To attach a ground to one of the chassis grounding studs, you need the following:
•
One single-hole cable lug that fits over one of the grounding studs
•
Nut and a locking washer for the grounding stud.
•
6-AWG grounding wire that is long enough to connect to the ground point.
•
7/16-inch hex wrench to fasten the hardware in the correct order.
Figure 39
this example, each chassis is configured with three DC power supplies.
Table 13
316314-D Rev 00
shows an example of how to ground two 8010co chassis and a BIP. For
Note: Your rack-grounding strip may look different or may be in a
different location than the one shown in the following example.
describes the reference items shown in
Figure
39.