Mounting the 8010co Chassis in a 19-inch rack
To install the 8010co Chassis in a 19-inch two-post rack:
1
Place the installation shelf at the bottom of the rack inside the rails.
2
Holding the installation shelf in position, align the shelf's mounting rail with
two holes on each side of the vertical rack support.
3
Insert a Phillips screw through each installation shelf mounting hole and into
the corresponding hole in the rack
4
Add a hex nut to each screw and tighten using a hex wrench.
5
Tighten each screw with a Phillips screwdriver.
6
If the holes in the rack's vertical supports requires clipnuts, insert a clipnut in
12 locations.
7
Using the chassis handles shown in
installation shelf.
Warning: It requires three people to lift the 8010co Chassis. You must
remove the I/O modules and power supplies before lifting.
Chapter 3 Installing the 8010co Chassis 57
(Figure
Figure
Installing and Maintaining the Passport 8000 Series Chassis
31).
30, lift the 8010co Chassis onto the