Resetting The Passport 8000 Series Switch; Figure 43 Reset Button - Nortel Passport 8000 Series Installing And Maintaining

Table 15 Boot mode at startup
if configuration is:
Mixed modules
All non-M modules
For information on using Device Manager or the CLI to configure M mode, see
Managing Platform Operations.

Resetting the Passport 8000 Series switch

You can use the Reset button on the following modules to reboot the Passport
8000 Series switch hardware without cycling power:
• 8190SM
• 8691SF
• 8692SF
To warm-start the Passport 8000 Series switch (no diagnostic tests are run), press
the Reset button for less than 5 seconds.
Figure 43

Figure 43 Reset button

Chapter 4 Operating the Passport 8000 Series switch 81
shows the location of the Reset button.
Console Modem (DTE)
Management Link
DCE|DTE
100
Installing and Maintaining the Passport 8000 Series Chassis
And M mode status at
startup is:
Disabled
Disabled
PCMCIA
Reset
Reset button
Then:
System starts in E mode
System starts in E mode
1 2 3
Utilization %
Power Supply
CPU
25 50 75 100 1 2 Temp
Fan
OPT0010A
Master
Online