Table of Contents
Advertisement
Figure 62. Checking disks for I/O operations
Warning: Run this command only on a new system. If any warnings related to existing
recovery group are detected, exist immediately.
Figure 63. Recovery group descriptor
Figure 64. Recovery group check for all disks
If there is any error that is detected, you must replace or reset drives and try again.
Press the Enter key to continue.
n. Highlight the Set FSP ipmi IP address (EMS or 3200) menu, press c key and then press the Enter
key.
Figure 65. Setting FSP ipmi IP address (EMS or 3200)
72 IBM Elastic Storage System 3200: Hardware Planning and Installation Guide
Advertisement
Table of Contents
