Table of Contents
Advertisement
Adjust the stty (use a larger value for rows/cols). For example,
stty rows 50 cols 150
Then press the Enter key.
Now execute essutils as root to run through the code 20 flow. You can also edit the essserv1
profile with this value and log back in as essserv1.
vi /home/essserv1/.profile
Edit the value and save. Then log in back as esserv1.
i. Note: The Assign IP address to Management Interface (ESS 3200 ONLY) menu is moved to the
beginning of the flow. After an IP address is set and verified that it is correct, disconnect serial and
connect your laptop via Ethernet to a free port on the management VLAN (yellow ports). Set a free
IP address on your laptop on the same network as the IP set on the canister(s).
For example, if you set the 192.168.45.20 IP address and the 255.255.255.0 netmask on one
of the canisters, you can set the 192.168.45.250 IP address and the 255.255.255.0 netmask on
your laptop (Check with the customer if .250 is free first).
Ping the canister from your laptop by using a terminal to ensure connectivity (example:
192.168.45.20). If you get a valid response ssh back into the canister to continue with the flow.
An example from PuTTY is as follows:
• ssh 192.168.45.20
• USERID: essserv1
• PASSWORD: <{Enclosure serial number}A|B>
If you are uncomfortable with switching to Ethernet, continue with the flow by using a serial.
Highlight the Assign IP address to Management Interface (ESS 3200 ONLY) menu, press C key
and then press the Enter key.
Figure 57. Assigning IP address to Management Interface (ESS 3200 ONLY)
A new panel opens. This new panel allows the SSR to change the IP address. Press the Ctrl + G
keys to save the changes.
Press the Enter key to execute. This sets the management IP address. For information, see the
Installation worksheet.
Note: You can see the updated IP address in the box at the bottom of the screen after the changes
are saved.
j. Highlight the Check management interface (3200) menu and press the Enter key.
This option confirms that the management IP set is applied correctly.
Chapter 4. Installing 69
Advertisement
Table of Contents
