Replacement Of The Blades - Husqvarna AUTOMOWER 535 AWD Operator's Manual

4. Make sure that the blade disc can rotate freely.
5. Make sure that the blades are not damaged and
can pivot freely.
6.3.2 To clean the chassis
• Clean the bottom of the chassis with a brush or a
moist cloth.
6.3.3 To clean the wheels
The product does not operate satisfactorily in slopes if
the wheels are blocked with grass.
• Use a soft brush to clean the wheels.
6.3.4 To clean the body of the product
• Use a moist cloth and a weak soap solution to
clean the body of the product.
6.3.5 To clean the charging station
WARNING:
supply from the power outlet before
maintenance, or when you clean the
charging station or power supply.
CAUTION:
Do not use a high-pressure
washer or running water to clean the
charging station.
Note:
The product cannot enter the charging station
if there are objects in the charging station. Clean the
charging station regularly.
• Remove grass, twigs and other objects from the
charging station.
30 - Maintenance
Disconnect the power

6.4 Replacement of the blades

WARNING:
guarantee safety if you use Husqvarna
original blades with the embossed crowned
H-mark logotype.
WARNING:
screws when you replace the blades. The
used screws can wear quickly and make the
blade come loose, this can cause serious
injury.
Replace worn or damaged blades for a safe operation.
Replace the blades regularly for a satisfactory cut result
and a low energy use. All 5 blades and screws must
be replaced at the same time to get a balanced cutting
system.
6.4.1 To replace the blades
1. Set the product to OFF. Refer to
to OFF on page 27 .
2. Put on protective gloves.
3. Put the product with the blade disc up on a soft
and clean surface.
4. Rotate the skid plate until its holes align with the
screws for the blade.
Husqvarna can only
You must replace the
To set the product
1427 - 009 - 20.12.2022