Clean The Product; Replacement Of The Blades And Blade Discs - Husqvarna CEORA Operator's Manual

2. Lift the rear part of the cutting deck and tilt the
lever.
3. Close the hatch.

6.5 Clean the product

Husqvarna recommends to use a special cleaning and
maintenance kit, available as an accessory. Speak to
your Husqvarna representative for more information.
CAUTION:
Do not use a high-pressure
washer to clean the product and the
charging station. Do not use solvents for
cleaning.
6.5.1 To clean the drive unit
The product does not operate satisfactorily in slopes if
the wheels are blocked with grass.
1. Loosen the clips with the flat screwdriver on the
Combi tool and remove the rear bumper.
2. Remove the wheel cover with the flat screwdriver
on the Combi tool.
1691 - 006 - 09.01.2023
3. Clean the body of the product, wheels and chassis
with a brush, compressed air or running water.
4. Examine and clean the wheel brushes. If
necessary, remove the screw and remove the
wheel brush to clean the shaft fully.
6.5.2 To clean the cutting deck and blade
discs
Examine the blade discs and blades weekly.
1. Put the product in service position. Refer to
the cutting deck in service position on page 32 .
2. Clean the blade discs, protection plate and the
wheels with a brush, compressed air and running
water.
3. Make sure that the blades are not damaged and
that the blades and blade discs can rotate freely.
6.5.3 To clean the charging station
WARNING:
cable from the power outlet before
maintenance, or when you clean the
charging station.
Note:
The product cannot go into the charging station
if there are objects in the charging station.
• Clean the charging station regularly from grass,
twigs and other objects.
6.6 Replacement of the blades and
blade discs
WARNING:
guarantee safety with the specified
Husqvarna original blades. Refer to
Technical data on page 49 .
T20
To put
Disconnect the mains
Husqvarna can only
Maintenance - 33