To make an island, isolate areas in the work area with
the boundary wire. We recommend to isolate all stable
objects in the work area.
Some obstacles are resistant to a collision, for example,
trees or bushes that are more than 15 cm / 6 in. in
height. The product will collide with the obstacle and
then select a new direction.
•
Put the boundary wire to and around the obstacle
to make an island.
•
Put the 2 sections of boundary wire to and from the
island close together. This will make the product
run across the wire.
•
Put the 2 sections of boundary wire in the same
stake.
•
Make sure that there is a minimum of 1.5 m / 5 ft of
empty space before an obstacle.
1.5 m/5 ft
0 cm/0"
3.4.4.4 To make a secondary area
Make a secondary area (B) if the work area has 2 areas
that are not connected with a passage. The work area
with the charging station is the main area (A).
14 - Installation
1.5 m/5 ft
B
A
Note:
The product must be manually moved between
the main area and the secondary area.
•
Put the boundary wire around the secondary area
(B) to make an island. Refer to
on page 13 .
Note:
The boundary wire must be put as 1 loop
around all of the work area (A + B).
Note:
When the product cuts grass in the
Secondary area mode must
secondary area, the
Secondary area on page
be selected. Refer to
26 .
3.4.5 To examine where to put the guide
wire
Put the guide wire from the charging station through
the work area and connect it to the boundary wire. This
product has 3 guide wires. Use the same approach for
all guide wires.
•
Put the guide wire in a line at a minimum of 2 m / 7
ft. in front of the charging station.
•
Make sure that the guide wire has as much free
area as possible to the left of the guide wire when
facing the charging station.
•
Put the guide wire minimum 30 cm / 12 in. from the
boundary wire.
•
Do not make sharp bends when you install the
guide wire.
135º
135º
To make an island
90º
1427 - 009 - 20.12.2022