Husqvarna AUTOMOWER 535 AWD Operator's Manual page 37

Message Cause
Battery temperature
The product does not operate if the battery
outside limits
temperature is too high or too low.
Faulty mix of batter-
The battery type is incorrect.
ies
Charging system
There is corrosion or dirt on the charging
problem
plates and contact plates.
Temporary electronic or firmware problem in
the product.
Charging current too
Wrong or faulty power supply unit.
high
Connectivity problem
Problem with the Automower
ule.
Connectivity settings The connectivity settings for the Automower
restored
Connect module was restored because of a
fault.
Outside work area
The boundary wire connections to the charg-
ing station are crossed.
The boundary wire is too close to the edge of
the work area.
The work area slopes too much by the boun-
dary loop.
The boundary wire is laid in the wrong direc-
tion around an island.
Disturbances from metal objects (fences, re-
inforcement steel) or buried cables close by.
The product finds it hard to distinguish the
signal from another product installation close
by.
1427 - 009 - 20.12.2022
Action
The product starts to operate again when the
temperature is between the set limits and the
schedule settings let the product to operate.
Make sure that the charging station is put in
an area with protection from the sun.
Only use original batteries that are recom-
mended by the manufacturer.
Restart the product. Clean the charging
plates on the product and the contact plates
on the charging station.
Restart the product. If the problem stays,
speak to your approved servicing dealer.
Restart the product.
If the problem remains, the message re-
quires action by authorized service techni-
cian.
®
Connect mod- Restart the product.
If the problem remains, the message re-
quires action by authorized service techni-
cian.
® Do a check of the settings and change the
settings if needed.
Make sure that the boundary wire is connec-
ted correctly. Refer to
put the boundary wire on page 11 .
Make sure that the boundary wire has been
laid according to the instructions. Refer to
install the boundary wire on page 16 .
Move the boundary wire and/or make more
islands in the work area to increase the sig-
nal strength.
Put the product in the charging station and
generate a new loop signal. Refer to
loop signal on page 24 .
To examine where to
To
New
Troubleshooting - 37