Husqvarna AUTOMOWER 535 AWD Operator's Manual page 23

4.4.2 To do a test of the boundary wire
Installation > Find charging station > Test:
1. Select
Boundary wire setup.
2. Put the product 3 m / 9 ft. from the boundary wire,
facing the boundary wire.
3. Push the START button.
4. Make sure the product follows the boundary wire to
the charging station.
5. Make sure the product docks with the charging
station.
6. Change the position of the charging station or the
boundary wire if the product does not dock with the
charging station. Refer to
station on page 15 and To install the boundary
wire on page 16 .
4.4.3 To do a test of the guide wire
Installation > Find charging station > Test:
1. Select
Guide 1-3 setup .
2. Put the product 3 m / 9 ft. from the guide wire,
facing the guide wire.
3. Push the START button.
4. Make sure the product follows the guide wire to the
charging station.
5. Make sure the product docks with the charging
station.
6. Change the position of the charging station or the
guide wire if the product does not dock with the
charging station. Refer to
station on page 15 and To install the guide wire on
page 16 .
4.4.4 Lawn coverage
The product has GPS Assisted Navigation that helps the
product to select the most optimal operation.
Use the Lawn coverage function to set manual settings.
Note:
If the GPS assisted navigation is enabled it is
on while there is a GPS service. The product uses the
manual settings for operation if the GPS service is not
available.
4.4.4.1 To set the Lawn Coverage function
Use the Lawn Coverage function for the product to cut
remote parts of the work area. Use the
function if the work area includes remote parts that are
connected with narrow passages to keep a satisfactorily
cut work area. You can set a maximum of remote areas
where the product starts to cut.
The product first follows the guide wire until the set
specified distance and then it starts to cut the work area.
Area A, approximately 50%
Area B, approximately 30%
1427 - 009 - 20.12.2022
To install the charging
To install the charging
Lawn Coverage
Area C, approximately 20%
A
Each area can be enabled or disabled. Use the
function to measure the distance from the charging
station to where the product must start to cut.
The default settings lets the product follow the guide
wire 300 m / 980 ft. in 20% of the times it moves out
from the charging station. If the guide wire is less than
300 m / 980 ft. the product will follow it to the point
where the guide wire is connected to the boundary wire.
4.4.5 Drive Past Wire
The front of the product always moves past the
boundary wire by a specified distance before the product
moves back into the work area. The factory setting for
Drive Past Wire function function is 31 cm / in. You
the
can select a distance of 20-50 cm / in.
Note:
With the factory setting the product will cut 11
cm / in. past the wire.
Note:
Drive Past Wire distance is changed,
If the
the distance will change along the boundary wire
everywhere in the work area.
4.4.6 Starting point
Starting point function allows you to control how
The
far the product drives forward from the charging station
before it starts to operate. Use this function if the
charging station is placed in an area with limited space.
Note:
Starting point must not be set to a distance
longer than the distance the guide wire is installed in a
line in front of the charging station. Refer to
where to put the guide wire on page 14 .
C
B
Test
To examine
Settings - 23