Clean The Product - Husqvarna AUTOMOWER 535 AWD Operator's Manual

To prepare
Examine the rubber grommets on the chassis to make sure that it is sealed
correctly.
Examine the skid plate and skid plate bearing.
Examine the rubber bellows in the cutting height adjustment system.
Examine the rubber bellows for the collision columns.
Replace the rubber bellows for the collision columns.
Examine and clean the airflow filter.
Replace the airflow filter.
Do a check of the tightening torque of chassis screws.
Open the chassis and replace all sealing strips.
Examine the front/rear wheel bearings and link arm bearings.
Last step
Use a software service tool to do a function test of the functions of the product.

6.3 Clean the product

CAUTION:
Never use a high-pressure
washer to clean the product. Never use
solvents for cleaning.
The product does not operate satisfactorily in slopes if
the wheels are blocked with grass. Use a soft brush to
clean the product.
Husqvarna recommends to use a special cleaning and
maintenance kit, available as accessory. Speak to your
Husqvarna representative for more information.
6.3.1 To clean the blade disc
Examine the blade disc and blades weekly.
1. Set the product to OFF. Refer to
to OFF on page 27 .
2. Put the product with the blade disc up on a soft
and clean surface.
1427 - 009 - 20.12.2022
3. Clean the blade disc with a brush.
To set the product
Weekly Every Every
year third year
O
O
O
O
O
O
O
O
O
O
O
Maintenance - 29