Husqvarna AUTOMOWER 535 AWD Operator's Manual page 13

> 1.5 m / 5 ft
0% - 50%
• Make sure that there is an area of cm / ft. between
level ground and steep slopes.
50cm / 1.6ft
35%
70%
0%
• For slopes adjacent to a public road, put an
obstacle of minimum 15 cm / 6 in. along the outer
edge of the slope. You can use a wall or a fence
as an obstacle.
3.4.4.2 Passages
A passage is a section that has boundary wire on each
side and that connects 2 parts of the work area. The
passage must be a minimum of 2 m / 6.5 ft wide to get
a good cutting result. Short passages can be as narrow
as 60 cm / 2 ft., if a guide wire is installed through the
passage. A long narrow passage can have a negative
impact of the cutting result.
Note:
If a passage is less than 2 m / 6.5 ft. wide,
install a guide wire through the passage.
The product always runs to the left of the guide wire
as seen facing the charging station. It is recommended
that the distance between the guide wire and boundary
wire is one third of the total width of the passage on the
right side and two thirds of the total width of the passage
to the left of the guide wire (A). The minimum distance
between the guide wire and the boundary wire is 30 cm /
12 in.
1427 - 009 - 20.12.2022
> 1.5 m / 5 ft
> 1.5 m / 5 ft
50% - 70%
50cm / 1.6ft
35%
0%
70%
>60 cm / 24"
A dead end must be a minimum of 2.5 m / 8.5 ft. wide.
3.4.4.3 To make an island
CAUTION:
Do not put a section
of boundary wire across the other. The
sections of boundary wire must be parallel.
CAUTION:
Do not put the guide wire
across the boundary wire.
CAUTION:
Isolate or remove obstacles
that are less than 15 cm / 6 in. in height.
Isolate or remove obstacles that slope
slightly, for example, stones, trees or roots.
This will prevent damage to the blades of the
product.
>30 cm / 12"
>2 m / 7 ft
>2.5 m / 8.5 ft
Installation - 13