Husqvarna AUTOMOWER 535 AWD Operator's Manual page 12

Hide thumbs Also See for AUTOMOWER 535 AWD:
Table of Contents

Advertisement

Put the boundary wire 30 cm / 12 in. (C) from an
obstacle that is 1-5 cm / 0.4-2 in. high.
30 cm / 12
Put the boundary wire 10 cm / 4 in. (D) from an
obstacle that is less than 1 cm / 0.4 in. high.
10 cm / 4
If you have a paving stone path that is in level with
the lawn, put the boundary wire below the paving
stone.
Note:
If the paving stone is minimum 30 cm / 12
in. wide, use the factory setting for the
Wire function to cut all the grass adjacent to the
paving stone. Refer to
Drive Past Wire on page
23 .
If you make an island, put the boundary wire that
runs to and from the island near together (E). Put
the wires in the same stake. Refer to
island on page 13 .
Make an eyelet (F) where the guide wire is to be
connected to the boundary wire.
12 - Installation
"
> 5 cm / 2
"
35 cm /14
"
"
1-5 cm / 0.4 - 2
"
"
max 1 cm / 0.4
Drive Past
To make an
3.4.4 To examine how to put the boundary
wire around the charging station
Husqvarna recommends to put the boundary wires
straight out from the charging station (A).
A
B
If it is necessary you can put the boundary wire
below the charging station in an angle (B).
Note:
Do not put the boundary wire too far below the
charging station. The product can find it hard to find and
enter the charging station.
3.4.4.1 To put the boundary wire in a slope
The product can operate in 70% slopes. Slopes that are
more than 70% must be isolated with the boundary wire.
The gradient (%) is calculated as height for each m.
Example: 10 cm / 100 cm = 10%.
10%
10 cm/4"
The product operates as usual in slopes that are
maximum 50% in the work area. Keep a distance
of 1.5 m / 5 ft between the boundary wire and
obstacles, or between obstacles.
For slopes between 50-70%, make sure that there
are no obstacles in the slope. There must be a
distance of 1.5 m / 5 ft m / ft from the bottom of the
slope to the boundary wire.
100 cm/40"
1427 - 009 - 20.12.2022

Advertisement

Table of Contents
loading

Table of Contents